Very interesting Arduino project which was coded in very popular Visuino IDE.
Main components are Arduino Nano together with GPS reciever and microSD card. Project was designed in IDE Visuino.
Arduino Nano periodically saves GPS data from reciver and saves it to microSD card.
Tutorial there: http://www.instructables.com/id/Arduino-Nano-Log-GPS-Information-to-MicorSD-Card-W/
The weather station is the first DIY project which makers do after sometime of playing with electronics. It is project which is helpful and makers using this long time. This article introduce my weather station which is based on board…
Notice by administrator: A few STM32 development boards (e.g. STM32L4 and IoT development board, STM32F723 and STMod+ connector) as well as Microchip development boards contain also PMOD connector List of Microchip Development boards with PMOD connector (selected) DM240001-2, DM160228, DM240001-3…
Maybe you read about a new board by STMicroelectronics and Arduino.org – Arduino STAR OTTO Arduino compatible board with STM32F469 microcontroller. In this article I describe you how to set your laptop, arduino IDE and how to upload your code…
I had to create development board with SIM908 – GPS&GSM&GPRS module for diploma thesis. The board is designed as top side. It’s easier than top and bottom sides. On the board are pin headers which are connected to the SIM908…
If you have our development board with SIM908 or something else, you have to know AT commands for GSM/GPRS/GPS module. Repetition again. You have to connect UART from SIM908 module to your microcontroller (Tx module – Rx microcontroller, Rx -…
The fourth part of STM32duino tutorial we will check the I2C bus. We connect the temperature and humidity sensor Si7021 to default I2C and also to alternative connection of I2C bus. Note: I2C on STM32(G071) was tested on 12.6.2023 with…
